Sharp XL-HP505 - Manual (Page 32)

32
XL-HP505
Adv
anced F
eatures
! Subwoofer connection
When a commercially available speaker with a built-in amplifier is
connected to this unit, you can enjoy sound with emphasized bass.
Connect an RCA cord from a commercially available speaker with a
built-in amplifier to the SUBWOOFER PRE-OUT jack.
Troubleshooting chart
Many potential problems can be resolved by the owner without call-
ing a service technician.
If something is wrong with this product, check the following before
calling your authorized SHARP dealer or service center.
! General
! CD player
Speaker with a
built-in amplifier
Symptom Possible cause
" The clock is not set to the
correct time. " Did a power failure occur? Reset
the clock. (Refer to page 15.)
" When a button is pressed,
the unit does not respond. " Set the unit to the power stand-
by mode and then turn it back on.
" If the unit still malfunctions, reset
it. (Refer to page 33.)
" No sound is heard. " Is the volume level set to "0"?
" Are the headphones connected?
" Are the speaker wires discon-
nected?
Symptom Possible cause
" Playback does not start. " Is the disc loaded upside down?
" Playback stops in the mid-
dle or is not performed
properly. " Does the disc satisfy the stan-
dards?
" Is the disc distorted or
scratched?
" Playback sounds are
skipped, or stopped in the
middle of a track. " Is the unit located near excessive
vibrations?
" Is the disc very dirty?
" Has condensation formed inside
the unit?