Sanitaire SC5800 Series - Manual (Page 10)

Brush Roll
The brush roll turns as it sweeps and combs the carpet nap.
Remove hair and threads from the brush roll so it continues
brushing the carpet. To maintain the most efficient cleaning,
the bristles must touch the carpet. To test the bristle length,
hold a ruler against the underneath side of the cleaner. If
the bristles no longer touch the ruler, replace the brush roll.
Brush Roll Belt, Style U
The brush roll belt turns the brush roll to agitate, sweep,
and comb the carpet nap. Check the belt regularly to be
sure it is in good condition. Replace the belt if it stretches,
cracks or loses tension. Cut away any hair or threads wound
around the brush roll or the belt pulley because the buildup
could cause the belt to rotate unevenly.
How To Replace Brush Roll Belt
NOTE: Turn off the switch and unplug the electrical cord
before replacing belt. Belt pulleys can become hot
during normal use. To prevent injury, avoid
touching the motor shaft when changing the belt.
PERIODIC MAINTENANCE
(CONTINUED)
1. Lower handle to floor to change belt.
2. Remove three screws indicated by screwdrivers in above
illustration. Lift hood to remove.
NOTE: The carpet height adjustment has to be in the
lowest or highest position to remove or reinstall
the hood.
IMPORTANT
9. Rotate brush roll by hand two full rotations
to properly position belt.
10. Place hood back on cleaner. Make sure hood front is
behind furniture guard. Replace three screws.
11. Tighten screws.
Use GENUINE EUREKA replacement belt, Style U. Look
for the GENUINE EUREKA product symbol.
10
1
2
2
2
3. Lift left end of brush roll.
4. Remove and discard old brush roll.
Brush
Roll
Belt
Motor
Shaft
4
3
9
6. Place new brush roll around motor shaft.
6. Place belt around brush roll pulley.
7. Align left end cap with base. Push end cap securely into
place.
8. Push right end cap into base until it snaps into place.
6
7
5
8