Operating instructions – Shark SV745 User Manual

Page 4

OPERATING INSTRUCTIONS

cont.

Changing & Cleaning the Dust Cup

Filter (cont)

4. Empty the dust from the dust cup

container. (See Fig. 10)

5. Rinse the dust cup filter in cold water,

and then wait until it dries completely

before replacing it back into the dust

cup container. Do not use a washing

machine to clean the dust cup filter.

Do not use a hair dryer to dry it. Air

dry only.

6. To empty liquids from the dust cup,

follow same instructions as above. Do

not let liquids in dust cup go over the

"MAX" level on the dust cup. (Fig. 11

& Fig. 12)

7. Replace the separator housing and the

dust cup filter carefully into the dust

cup compartment. NEVER operate

vacuum cleaner without the

separator housing and the dust cup

filter in place.

8. Attach the dust cup container to the

cordless vacuum.

Using Your Cordless Wet/Dry

Vacuum

1. Remove the vacuum cleaner from

the charging base

2. To start the unit, push the "On/Off"

switch to the "On" position.

3. To stop the vauum cleaner, slide

the "On/Off" switch to the "Off"

position.

Crevice Tool

A crevice tool is provided

for cleaning narrow, hard

to reach places.
Convertible Brush

A convertible brush is

provided for cleaning

upholstery, furniture,

etc.
Squeegee Nozzle

A squeegee nozzle is

provided for picking up

any liquid spills.

Fig. 6

Assembly (cont.)

4. To use the extension hose with

convertible brush, crevice tool or

squeegee nozzle, push the

smaller end of extension hose

into the suction hole, then

push the selected

accessory into the

other end. (Fig. 6)

IMPORTANT: WET PICK-UP

When using this vacuum for wet pick-up,

NEVER fill past the "MAX" level mark on the

dust cup housing. Maximum capacity

(liquid) is 6 US Fl. Oz. (180 ml). Never tip

the unit upward past horizontal when

vacuuming liquids. Keep suction inlet

pointed downward. Always empty the dust

cup after using the vacuum to pick up

liquids.

Assembly

Note: Dust cup filter and separator

must always be used when

operating the hand vacuum.

1. To open the dust cup compartment,

push the dust cup release button

and remove the dust cup

container. (Fig. 2)

2. Verify that the dust cup filter and

the separator housing are inside,

then re-attach the dust cup

container to the wet/dry hand

vacuum. (Fig. 3 & Fig. 4)

Before Use

1. This cordless wet/dry hand vacuum is

cadmium batteries. Before using the

vacuum, charge the vacuum cleaner

for a minimum of 20 hours.

NOTE: Ensure that the On/Off

switch is in the “Off” position

before charging.

NOTE: Peak performance may only

be realized after the unit has been

charged and discharged two (2) or

three (3) times.

Fig. 2

IMPORTANT: To maintain peak

performance of your cordless hand

vacuum, it is recommended that the

unit be fully discharged, then

completely re-charged at least once a

month.

Fig. 3

2. Store the vacuum cleaner in the

charging base when not in use so that

it is always charged and ready to

use.

Fig. 7

Fig. 8

Fig. 9

Fig. 10

Fig. 11

Fig. 12

Charging Your Vacuum Cleaner

1. Place the charging base near an

electrical power outlet (120 V., 60 Hz.)

and plug in the charging adapter's jack

into the charging base.

2. Plug the charger into wall outlet.

3. Place the unit in the charging base. The

charging indicator light will shine red to

indicate that the vacuum cleaner is

properly positioned in the charging base

and that the unit is being charged.

(See Fig. 1)

NOTE: Ensure that the On/Off

switch is in the "Off" position

before charging.

3. To attach the convertible brush,

crevice tool or squeegee nozzle to

the wet/dry hand vacuum, push the

attachment into the suction hole in

the front of the dust container.

(Fig. 5)

Fig. 5

Fig. 4

NOTE: When vacuuming up liquids,

ensure that you do not go over the

"MAX" level on the dust cup. Capacity

is 6 US Fl. Oz. (180 ml.).

NOTE: It is recommended that the dust

cup filter be replaced every three (3)

months to ensure peak performance of

the unit.

Charging

Receptacle

Charging

Jack

Fig. 1

Changing & Cleaning the Dust Cup Filter

To achieve the best performance, empty

the dust cup container and clean the

dust cup filter after each use.

1. To remove the dust cup container,

press down on the dust cup release

button and pull off the dust cup

container. (Fig. 7)

2. Pull out the dust cup filter. (Fig. 8)

3. Pull out the separator housing. (Fig. 9)

CAUTION: The suction hole must be

open and free of any obstructions at all

times. Otherwise, the motor will

overheat and could become damaged.