Siemens CXT65 - Manual (Page 12)

©
Siem
ens AG
2003, I
:\Mob
il\R6
5\CX65_U
ly
sses\en\_v
on_it
l\fug\C
X
65
_St
artup.fm
11 Getting started
VAR Langua
ge: English; VA
R issue
da
te
: 1
8-Fe
bruar
-2004
left page (11) of CX 65 Ulysses FUG en, A31008-H7100-A1-1-7619 (04.03.2004, 14:15)
Changing CLIPIt™
covers
You can use CLIPIt™ covers (accesso-
ries) to adjust the appearance of
your phone according to your per-
sonal taste.
Please switch the phone off before
changing the keypad mat or face-
plate.
Dismantling the phone
Remove battery cover (see p. 9). To
remove the faceplate, insert the lug
on the battery cover into the open-
ing and open the lock by simultane-
ously applying slight pressure
1
and
turning the lug
2
.
Assembling the phone
Remove the old keypad mat and
insert the new keypad mat
3
into
the faceplate. Take care that it is cor-
rectly positioned.
Insert the phone into the bottom of
the faceplate
4
and then push it in
carefully until it clicks into position
5
.
Additional information
The power supply unit heats up when used
for long periods. This is normal and not
dangerous.
If the battery is removed for longer than
30 seconds, the clock must be reset.
1
2
CLIPit™ Covers
The new keypad has an additional key
beneath the joystick to permit direct access
to the Internet information from the service
provider.
3
4
5