Skil 2895 - Manual (Page 11)

With the button still depressed, continue
sliding the stud finder in the same direction
until the red LED turns off. This is the stud’s
other edge. Mark this spot.
The midpoint of the two marks is the center of
the stud.
A fault has occurred when all three LEDS
flash . To correct, simply restart the circuit.
Stud finders can detect
other objects besides
studs, such as electrical wiring and
metal/plastic pipes. Contact with a “live” wire
will make exposed metal parts of the tool “live”
and shock the operator.
(Studs are normally spaced 16 or 24 inches
apart and are 1-1/2" wide. Beware of anything
closer together or of a different width.) Always
turn off power when working near electrical
wires.
-11-
FIG. 5
! WARNING
BUTTON
RED LED
LINE
YELLOW LED
GREEN LED
RELEASING AND INSERTING
BATTERY PACK
Release battery pack from tool by pressing the
battery release button and sliding pack out of
handle base (Fig. 1). To insert battery, align
battery and slide battery pack into tool until it
locks into position. Do not force.
Plug charger cord into your standard power
outlet, then slide the battery pack into charger
(Fig. 6).
The charger’s green indicator will begin to
“BLINK”. This indicates that the battery is
receiving a fast charge. Fast-charging will
automatically stop when the battery pack is
fully charged.
When the indicator light stops “BLINKING”
(and becomes a steady green light) fast
charging is complete.
When you begin the charging process of the
battery pack, a steady green light could also
mean the battery pack is too hot or too cold.
The purpose of the light is to indicate that the
battery pack is fast-charging. It does not
indicate the exact point of full charge. The light
will stop blinking in less time if the battery pack
was not completely discharged.
When the battery pack is fully charged, unplug
the charger (unless you're charging another
battery pack) and slip the battery pack back
into the tool handle.
CHARGING BATTERY PACK (FAST CHARGER)
INDICATOR LIGHT
CHARGER BATTERY PACK
FIG. 6
BATTERY
RELEASE BUTTON
SM 1619X03409 05-08 5/6/08 2:45 PM Page 11