Peration – Southbend 4FR-45 User Manual
Page 12
O
PERATION
4FR-45 R
ESTAURANT
R
ANGE
F
RYER
P
AGE
12
O
PERATOR
’
S
M
ANUAL
1182128
OP
E
R
ATIO
N
O
PERATION
NOTICE
These procedures must be followed by qualified personnel or warranty will be voided.
The Southbend 4FR-45 Restaurant Range Fryer is an immersion tube fryer. This is the most efficient method
of transmitting heat into the oil. The tubes are actually large heat exchangers. Each tube is heated by a
burner at its front that propels its flame and heat into the tube, toward the rear, where it is vented into a flue
box. The combined heat transfer area of the tubes is much greater than the other types using element coils
or under-fired pots. Consequently, heat transfer per square inch is lower, as is the temperature, but because
of the increased surface area, immersion tube fryers transfer more heat into the oil. The lower temperature of
the heating surface prevents scorching and carbonization of the oil. Higher heat transfer rate gives faster
recovery between loads.
Another advantage of immersion tube fryers is the cold zone. As oil is heated it passes between and over the
tubes and rises into the frying zone, where it imparts heat into the product. After giving up heat, it descends
to the cooler zone below the tubes. Food particles and crumbs are dropped and trapped in the cold zone as
the oil awaits to be recirculated. The cold zone concept helps keep the oil circulating and clean of debris.
!
WARNING
BURN HAZARD
Contact with hot oil will cause severe burns. Always use caution. Oil at 200
°
F is more dangerous than
boiling water.
!
CAUTION
NEVER OPERATE THE FRYER WITHOUT SUFFICIENT OIL TO COVER THE TUBES.
Lighting
!
CAUTION
IF YOU SMELL GAS DURING THE LIGHTING PROCEDURE, IMMEDIATELY SHUT OFF THE GAS
SUPPLY UNTIL THE LEAK HAS BEEN CORRECTED.
Open the burner compartment door and do the following:
1. Turn thermostat to “OFF” (lowest position).
2. Press down the knob of the combination gas
valve, turn it counterclockwise to the “PILOT”
position, and continue to press the knob down.