Sanitaire S634 - Manual (Page 5)

UP
THROAT
BOTT
OM
UP
THROAT
BOTT
OM
HAUT
GORGE
BAS
5
How To Change Disposable Dust Bag–Style F
& G, PN 54924A
CAUTION: Turn off the switch and unplug the electrical
cord before changing dust bag. Never operate
the vacuum cleaner without the dust bag.
Cleaner Care
CAUTION: Turn off the switch and unplug the electrical
cord before cleaning unit.
To keep the vacuum cleaner looking new, it can be wiped with
a damp cloth and a mild soap solution, then thoroughly dried.
Never use any type of chemical as chemicals can damage
the cleaner. When not in use, the cleaner should be stored
in a clean, dry place.
Ask for GENUINE EUREKA dust bags – Style F & G.
Look for the symbol. Look for the symbol.
GENUINE
Look for the symbol. Look for the symbol.
6. Roll up coil spring.
7. Place paper bag into outer bag.
NOTE: Be certain there are no folds
at the top or bottom of the
paper bag.
8. Lift zipper
4. Unfold
new bag.
3. Pull bag
throat off
sleeve.
1. Pull
zipper
down
5. Place bag
throat on
sleeve.
THROAT THROAT
2. Roll down
coil spring.
Brush Roll Belt
The brush roll belt on the upright vacuum cleaner drives the
brush to agitate, sweep, and comb the carpet nap. The belt
should be checked regularly to be sure it is in good condition.
Replace the belt if it is stretching, cracking, or slipping. Cut
away any hair or thread wound around the brush roll or the
belt pulley because the buildup could cause the belt to rotate
unevenly.
How To Replace A Worn Belt, Style RD,
PN 52100A
CAUTION: Turn off the switch and unplug the electrical
cord before replacing belt. Belt pulleys can
become hot during normal use. To prevent
injury, avoid touching the belt pulley when
servicing the drive belt.
IMPORTANT: Improper installation of the brush roll
or brush roll belt could cause carpet or
cleaner damage.
1. Release cam locks.
Guide Guide
Check for brush wear, see Brush Roll instructions.
3. Place new belt around brush roll.
4. Align brush roll pulley with belt guide.
Brush Roll Pulley
Motor
2. Pull up on belt to rotate it off the motor pulley. Lift
up on brush roll and remove worn belt.