Shindaiwa 89300 - Manual (Page 7)

WARNING!
NEVER use this machine with-
out sub-shield when using a trimmer
head.
T unit
TX unit
CAUTION!
Make sure the sub-shield is completely
hooked at the hook receiver.
Sub-Shield
(when trimmer head is in use)
Attach the shield extension to the cutting 1.
attachment shield.
Sub-shield Hook
Hook Receiver
Cutting Attachment Shield
Attach the sub-shield to the cutting attachment
shield for TX units when using a trimmer head
Outer Tube Socket-Head
Cap Screws
Clamp Screw
Retaining
Nut
Mounting Plate
Shim
Shim
Bracket
Cutting Attachment
Shield w/subshield
Line Cutter
Outer Tube
Socket-
Head Cap
Screws
Clamp Screw
Retaining
Nut
Mounting Plate
Shim
Shim
Bracket
Line Cutter
Cutting Attachment
Shield
Cutting Attachment Shield - T, TX unit
7
CAUTION!
Make sure the clamp screw and
retaining nut are securely tightened
before tightening the four socket-
head cap screws.
Assembly (continued)
Insert the cutting attachment shield 1.
between the outer tube and the cutting
attachment mounting plate.
WARNING!
NEVER operate the unit with-
out the cutting attachment shield
installed and tightly secured!
NOTE:
It may be necessary to loosen the retain-
ing nut and clamp screw to adjust cutting
attachment shield mounting plate.
Fit the two shims and the bracket over 2.
the outer tube and loosely install the
four socket-head screws.
Tighten the four socket-head cap 3.
screws to secure the cutting attach-
ment shield.