Spracht AURA SOHO CP-2016-003 - Manual (Page 8)

Using the Aura SoHo™ Conference Phone
TO MAKE A CALL
Press the Power Button � to turn on the Aura SoHo™
Conference Phone, then enter the phone number for your
call.
ADJUST SPEAKER VOLUME
Press the Volume Up ^ or Volume Down v button to adjust
the speaker volume.
ANSWER A CALL
Press the Power Button � when the Aura SoHo™
Conference Phone rings.
END CALL
Press the Power Button � to end a call.
REDIAL
Press the REDIAL button to call the last number dialed.
PLACE CALL ON HOLD
Press the HOLD button to place a call on hold. The bottom
indicator light near the Power Button � will blink when
on hold. Press the HOLD button again to resume the call.
MICROPHONE MUTE
Press the MUTE button to turn off the microphones in the Aura
SoHo™ Conference Phone. The red indicator light above the MUTE
button will be on when muted. While in MUTE mode, you will be
able to hear the other end of the call, but they will not hear you.
Press the MUTE button again to resume speaking to the caller(s).
The red light will go out.
CONFERENCE NOW
The patented ConferenceNow™ button allows for you to press
one button to connect with the Conferencing Service.
FLASH
The FLASH button is for three way conferencing. It allows you to
put your first caller on hold while dialing the second number. Dial
your first number normally. When the person is on the line, press
the FLASH button and you will hear a second dial tone. Dial the
second number. When that person is on the line, press the FLASH
button again and all three of you will be on a conference call.
10 11