Summit HP-1S - Manual (Page 13)

ADJUSTMENTS FOR SEATING COMFORT
To maximize seating comfort, your power wheelchair lets you adjust:
B
Armrest height.
B
Controller position.
B
Flip-back and detachable armrest.
B
Footrest height.
A. Armrest height
(Adjustable up to 4” in 1” increments)
To adjust the armrest height, pull and hold the
button on the arm sub-assembly, lift the armrest
up to the desired height (Fig. 11). Release the
button when the armrest is locked.
B. Controller position
Unscrew the lever underneath the armrest
(Fig. 11). Slide the supporting bar for the
controller to the desired length. Screw back
the lever to lock the controller position.
Controller can be placed either on the left
side or on the right side. No extra spare parts
are needed.
C. Flip-back and detachable armrest
The armrests can be flipped back to easily access
the wheelchair (Fig. 12). You can flip back the arm
Sub-assembly by pressing and holding the button
located in the front bottom of the side panel. To
detach the arm sub-assembly, remove the pin at
the rear bottom of the arm sub-assembly (Fig. 12).
D. Footrest height
The swingaway footrests are height adjustable. To
increase or decrease the height of the footplate,
unscrew the bolt at the rear of the hanger (Fig. 13).
The bolt is located just below the hexagonal part
of the hanger. Slide the footplate to the required
height and then re-tighten the bolt.
Page 11
Fig. 11
Fig. 13
Button
Lever
Fig. 12
Button
Pin