Sony HBH-60 - Manual (Page 12)

No
t fo
r C
om
me
rci
al U
se
12 Troubleshooting
Headset battery status
With the headset on in standby mode, press and release
both
and . The battery status is indicated
by one of these three signals, after an initial long
green flash:
• High – three green flashes
• Medium – two green flashes
• Low – one green flash
Resetting the headset
You may want to reset the headset to its default
settings. This also clears all current pairings.
To reset the headset
1. With the headset turned off, press and hold the call
handling button for up to 10 seconds until the
indicator light on the headset flashes green and red.
Then release the button.
2. Press and hold the call handling button again until
you hear one low beep, followed a moment later by
another two beeps. The headset is now turned off,
and has been reset.
Troubleshooting
No sound contact between headset and phone
The headset and the phone you are using with it have
to be paired to recognize each other.
They also have to be within range of each other.
Make sure that there are no solid objects, such as walls
or furniture, in between the headset and the phone.
The indicator light flashes red
This indicates that the headset has only limited talk and
standby time left. Charge the headset battery for
approximately 1 to 1.5 hours.
The indicator light flashes green twice
In standby mode, the indicator light might flash green
twice rapidly at intervals of approximately 3 seconds.
This indicates that there is no mobile network within
range. Move to get a signal that is strong enough, or try
searching for a new network in the GSM networks
menu of your phone.