Multiquip MS30H - Manual (Page 13)

MQ STOW MS30H/MS30E MIXER — PARTS & OPERATION MANUAL — REV. #4 (08/10/06) — PAGE 13
MS30H/MS30E MIXER — GENERAL INFORMATION
GENERAL
The MQ STOW Model MS30H (Honda GX240K1) gasoline
engine) and MS30E (electric motor) plaster and mortar mixers
are shipped completely assembled and have been factory tested.
The drum batch capacity of these mixers is between 3.5 and
4.0 bags. With proper care, they will give continuous service
year-after-year.
These mixers can be powered by either gasoline or electric
motors. The shaft of the engine or electric motor is connected to
a drive belt pulley which is attached to a main gear. As the main
gear rotates it causes the paddle shaft to rotate.
BEFORE STARTING
Before starting the engine, read the engine owners manual and
thoroughly understand the safety information.
Check the items listed below:
OIL LEVELS
Be sure to check the oil levels in the engine and engine reduction
unit before starting the unit (gasoline model only).
HARDWARE
Check all hardware on the mixer before starting. Periodically
inspect all hardware. Loose hardware can contribute to early
component failure and poor performance. Use the torque chart
below as a general guideline and keep all hardware tight:
HARDWARE DIA TORQUE (LB./FT.)
5/16"- 18 24
3/8" - 24 37
1/2" - 13 39
1/2" - 13 (Grade 8) 90
GASOLINE ENGINE CARE
For care and operation of the gasoline engine, refer to the engine
manufacturer’s operating instructions furnished with the engine.
We recommend draining and refilling the engine crankcase at
least every thirty hours of operation. Check the engine oil level
daily.
GASOLINE MIXER OFF/ON SWITCH
This feature is on gasoline engine mixers only. Located on the
side of the engine cover. The purpose of this switch is to start
and stop the mixer in normal operation.
ELECTRIC MOTOR MIXER OFF/ON SWITCH
This feature is on electric motor mixers only. This switch is located
on top of the motor. Lift the engine cover to gain access to this
switch. The purpose of this switch is to start and stop the mixer in
normal operation. NEVER use the electric motor in an explosive
environment.
ENGINE THROTTLE AND CHOKE CONTROLS
Please refer to the engine owners manual for specific instructions.
NOTE
In accordance with our established
policy of constant improvement, we
reserve the right to amend these
specifications at any time without
notice.