Sunbeam HE2800 - Manual (Page 8)

6
1. Place the heater on a flat level surface
and ensure that the air intake and air
outlet are clear of obstructions.
2. Insert the plug into a 230-240V power
outlet and turn the power on.
3. Move the on/off switch at the rear of the
unit to the on (I) position. A beep will
sound.
4. Press the power button on the control
panel to turn the heater on. The LCD will
display the current room temperature and
HIGH, indicating that it is operating in
HIGH heat mode.
5. Press the MODE button to cycle through
the various operating modes:
LOW – the heater will continuously run at
its low wattage.
AUTO - the digital thermostat will cycle
the heater on and off to maintain your
selected temperature. See instructions on
setting the digital thermostat below.
HIGH - the heater will continuously run at
its high wattage.
6. To turn the heater off, press the power
button on the control panel. The heater
will stop operating.
7. Move the on/off switch at the rear of the
unit to the off position (O). Turn the power
off and remove the plug from the power
outlet when not in use.
Setting the digital thermostat
1. Press the mode button to select AUTO
mode. AUTO will appear on the LCD
screen, and the current room temperature
will flash.
2. Use the Temp + and – buttons to select
the desired temperature setting. SET,
TEMP and the selected temperature will
flash several times to indicate that the
thermostat is set. The LCD will return to
displaying the room temperature.
3. Once the room temperature reaches 3°C
above the selected temperature, the heater
will operate for a further 20 seconds and
then cutout. When the room temperature
drops below the set temperature, the
heater will switch back on. The thermostat
will continue to cycle the heater on and off
to maintain your selected temperature.
4. To view the set temperature, press the
Temp button. The set temperature setting
will flash on the screen.
5. To turn the heater off, press the power
button on the control panel. The heater
will stop operating.
6. Move the on/off switch at the rear of the
unit to the off position (O). Turn the power
off and remove the plug from the power
outlet when not in use.
Using your Oscillating Digital
Ceramic Heater
Fig. 2