Starting cold engine, Two-hand operation, Maintenance – Shindaiwa X7501920300 User Manual
Page 12: Throttle control
12
IMPORTANT!
To avoid engine damage due to over-revving do not block blower pipe.
1. Use only during appropriate hours.
2. Control engine speed with throttle lever, or for continuous use, set en-
gine speed with throttle lock lever.
3. Use lower speed to blow debris from hard surfaces. Additional speed
may be necessary to clean debris, snow, etc. from lawns and flower-
beds.
Note:
Never use a higher speed setting than necessary to perform a task. Re-
member, the higher the engine speed, the louder the blower noise. Mini-
mize dust by using blower at lower speeds. Keep debris on your property.
Be Smart - be a good neighbor.
Two-hand Operation
For added comfort and control, grip throttle control handle with left hand, and
lower handle/stand with right hand.
IMPORTANT!
Maintenance, replacement or repair of emission control devices and systems
may be performed by any repair establishment or individual, However, war-
ranty repairs must be performed by a dealer or service center authorized by
Echo, Inc. The use of parts that are not equivalent in performance and dura-
bility to authorized parts may impair the effectiveness of the emission control
system and may have a bearing on the outcome of a warranty claim.
Maintenance
WARNING!
Non-standard parts may
not operate properly with your unit
and may cause damage and lead
to personal injury.
NOTE:
Using non-standard replacement parts could invalidate your Shindaiwa warranty.
WARNING!
Before performing any
maintenance, repair or cleaning
work on the unit, make sure the
engine is completely stopped. Dis-
connect the spark plug wire before
performing service or maintenance
work.
IMPORTANT!
Inspect the entire blower for loose, damaged, or missing components, and
repair as necessary.
Throttle Control