Trouble shooting battery safety information – Sportline Cardio 660 Women's Heart Rate Monitor SP1449S015SPO User Manual

Page 13

Cardio 660w Heart rate monitor

potentIal Causes for no heart rate readIng or long

response tIme:

Cause:

dry skin

solutIon:

apply conductive gel thoroughly to chest area (for

Chest-strap measurement). tap water may help if conductive

gel is not available.

Cause:

Chest strap is not contacting with skin

solutIon:

make sure the chest strap is firmly over the chest and

the watch is securely on wrist.

Cause:

dead or flaking skin on chest.

solutIon:

rub off excessive dead skin with a towel

Cause:

a thin layer of body grease insulates the eCG signal pre-

venting the Chest strap or watch from detecting eCG heart rate

solutIon:

wipe chest / wrist and the back of Chest strap/

watch with a tissue or soft towel.

Cause:

Hairy skin

solutIon:

apply conductive gel to chest area or wrist.

Cause:

low Battery

solutIon:

replace the battery in watch/transmitter and try

again.

Cause:

electrical field interference from rf devices (Chest-

strap measurement) such as overhead power lines, etc.

solutIon:

leave the area where rf source potentially exist.

Cause:

issues acquiring heart rate.

solutIon:

try resetting the exercise timer which will tell the

watch to begin acquiring heart rate again (see pg. 16).

solutIon:

make sure watch and transmitter strap are coded

correctly (see pg. 11).

CautIon – battery safety InformatIon
• non-rechargeable batteries are not to be recharged
• rechargeable batteries must be removed before recharging
• rechargeable batteries should only be recharged under

adult supervision

• do not mix alkaline, standard (carbon-zinc), or recharge-

able (nickel-cadmium) batteries

• exhausted batteries are to be removed
• do not mix old and new batteries
• do not dispose of product or batteries in fire; batteries may

explode or leak

• if this product will not be used for an extended period of

time, remove the batteries from the product

• the supply terminals are not to be short-circuited
• Batteries are to be inserted with correct polarity
• Clean the battery contacts and also those of the product

prior to battery installation

• as always, dispose of batteries in an eco-friendly manner

the purpose of the crossed-out wheelie bin symbol is to remind us

that most electrical products, and batteries, contain trace elements

(including mercury – Hg, Cadmium – Cd and lead – Pb) which could

be harmful to our environment and therefore our health. we must all

be careful to dispose of them responsibly in a specifically designated

way – either using a collection scheme or into the correctly labeled

civic amenity (not into general waste) – this will help your local

authority to arrange to recycle or dispose of them in the appropriate

manner.

trouble shooting

battery safety information