John Lewis GAS HOB JLBIGGH605 - Manual (Page 15)

15
3
Dimensions are given in mm.
Building over a kitchen Building over a kitchen Building over a kitchen Building over a kitchen Building over a kitchen
unit with door unit with door unit with door unit with door unit with door
Proper arrangements must be taken in
designing the furniture unit, in order to avoid
any contact with the bottom of the hob which
can be heated when it is operated. The
recommended solution is shown in diagram
3.
The panel fitted under the hob ("a") should
be easily removable to allow easy access if
technical assistance is needed. The space
behind the kitchen unit ("b") can be used for
connections.
Fitting the Hob into the Fitting the Hob into the Fitting the Hob into the Fitting the Hob into the Fitting the Hob into the
W W W W Worktop orktop orktop orktop orktop
Before fitting the hob into the cut out, an
adhesive seal must be fitted to the underside
outside edge of the hob. It is essential that no
gaps are left in this seal in order to prevent
spillage near the hob seeping into the cabinet
below.
1) Remove the pan supports, the
burners caps and crowns and turn
the hob upside down, taking care
the ignition candles are not
damaged in this operation.
2) Place the sealing gasket all around
the glass top edge as shown in
diagram 4.
3) Fit the hob in the cut out and push
it down until the glass top and the
working top make contact, as
shown in diagram 5.
AAAAA
A) A) A) A) A) Sealing gasket
4
5