GE 24914 GE Universal Remote - Manual (Page 12)

12
Volume/Mute Control and Punch-Through
This remote lets you select which device Mode
controls your Volume/Mute buttons. The remote
is initially set for all device Modes to use their own
Volume/Mute control if present. If the programmed
code has no Volume/Mute operation of its own then
those buttons will punch-through control to the
TV
Mode device without needing to change to TV Mode.
Any Mode chosen for Volume/Mute control MUST
have its own Volume/Mute function or the Volume/
Mute buttons will do nothing.
Setting ALL Volume/Mute Control to any
one Mode
This routine can set all Modes to “punch-through”
to any one chosen Mode for Volume/Mute button
control without the needing to change to that
Mode.
1. Press and hold the
SETUP button until the red
indicator turns on, then release the button.
2. Press and hold the MUTE button until the red
indicator blinks off, then release the button.
3. Press and release the desired Mode button
( TV, VCR, etc.) for Volume/Mute control, the
red indicator blinks then stays on.
4. Press and release the MUTE button
and the red indicator turns off. The
red indicator will blink rapidly for three
seconds if the Mode you have selected
has no Volume/Mute control.
All other Modes will now punch-through to
your chosen Mode for Volume/Mute control.
Using Your Remote, cont.