Jotul GI 425 DV - Manual (Page 19)

19
Brick Panel Assembly
CAUTION: THESE PANELS ARE EXTREMELY FRAGILE!
SUPPORT EACH PIECE WITH BOTH HANDS AND
HANDLE TENDERLY.
Install the optional Brick Panel Kit 155311 before
placing the Logset. Place the panels in position in
the order as numbered in Fig. 17. No fasteners or
tools are required.
1. Remove the Glass Frame, if you have not already
done so. Remove the Ashlip and locate the two
frame latches under the firebox floor. See Fig. 18.
Pull the latch handles forward to disengage them
from the bottom of the glass frame. You can then
pull the frame out and up off of the three retainer
tabs at the top of the firebox opening. Set the
Glass Frame out of the way.
2. Remove the Fettle and Logset. These parts are not
fastened. Simply lift them out of the firebox.
3. Install the Lower Rear Panel. Orient the panel so
that the cutout is at the bottom. Engage the
bottom edge between the rear wall and the
firebox base. See Fig. 17.
4. Install the Side Panels. Engage the bottom edge
of each side panel between the Logset Base and
the firebox wall and push the panel forward
against the front lip of the firebox opening. See
Fig.20.
5. Install the Upper Rear Panel. This will also be a
snug fit. Set the panel up high and then carefully
lower it to seat its lower edge against the top of
the other rear panel. The side panels will hold it in
place.
6. Install the Logset (see pg. 20).
7. Replace the Fettle, Andirons and Glass Assembly.
Figure 18. Glass Frame latch locations.
Pull Frame Latches to
Release Frame
Figure 20. Install the Side Panel.
Side
Panel
Figure 19. Install Lower Rear Panel.
Logset Base
Figure 17. Panel installation order.
Left Side
Panel,
220516
Right Side
Panel,
220517
Lower Rear Panel,
220514
Upper Rear Panel,
220515
4
3 2
1