JBL KHM10 - Manual (Page 4)

SPECIFICATIONS
KHM10
Description 3-Speaker, 2-way 250mm (10") karaoke monitor
Maximum Recommended Amplifier Power** 175W
Power Handling (Continuous/Peak) 50W/400W
Nominal Impedance 8 Ohms
Sensitivity (2.83V/1m) 92dB
Frequency Response (–3dB) 40Hz – 20kHz
Crossover Frequency 1,700Hz
High-Frequency Transducers Dual 75mm (3") cones with high-temperature voice coil
Low-Frequency Transducer 250mm (10") Cone with high-temperature
voice coil, shielded
Baffle Low diffraction, IsoPower ™
Ports Dual FreeFlow ™ flared
Network Straight-Line Signal Path ™ (SSP ™ )
with left and right high-frequency trim controls
Terminals Gold-plated, 5-way binding posts
Dimensions (H x W x D) 330mm x 533mm x 241mm (13" x 21" x 9-1/2")
Weight per Speaker 12.7kg/28 lb
Declaration of Conformity
We, Harman Consumer Group International
2, route de Tours
72500 Chateau-du-Loir
France
declare in own responsibility that the product described in
this owner’s manual is in compliance with technical stan-
dards:
EN 61000-6-3:2001
EN 61000-6-1:2001
Laurent Rault
Harman Consumer Group International
Chateau-du-Loir, France 5/05
© 2005 Harman International Industries, Incorporated. All rights reserved.
JBL is a registered trademark of Harman International Industries, Incorporated.
Part No. 000-111
PRO SOUND COMES HOME ™
JBL Consumer Products, 250 Crossways Park Drive, Woodbury, NY 11797 USA
8500 Balboa Boulevard, Northridge, CA 91329 USA
2, route de Tours, 72500 Chateau-du-Loir, France
516.255.4JBL (4525) (USA only) www.jbl.com
** The maximum recommended amplifier power rating will ensure
proper system headroom to allow for occasional peaks. We do
not recommend sustained operation at these maximum power
levels.
All features and specifications are subject to change without
notice.
All dimensions include grilles.
STEAL THE SHOW
GO PRO
If the system plays at
low volumes but shuts
off as volume is
increased:
• Check all wires and connec-
tions between receiver/
amplifier and speakers.
• Make sure all wires are con-
nected. Make sure none of
the speaker wires are frayed,
cut or punctured.
• If more than one pair of main
speakers is being used, check
the minimum impedance
requirements of your
receiver/amplifier.
If there is no (or low)
bass output:
• Make sure the polarities
(+ and –) of the left and right
“Speaker Inputs” are con-
nected properly.
• Consider adding a powered
subwoofer to your system.
®
KHM-10 OM 5/10/05 3:05 PM Page 2