Jacuzzi Real Salon DT00 - Manual (Page 2)

Real® Salon™ Spa
Model: DT00
Installation Notes
Refer to installation instructions included with fixture before beginning installation.
Please confirm product availability and specifications before commencing with any
installation work.
PRODUCT SPECIFICATIONS AND AVAILABILITY ARE SUBJECT TO CHANGE
WITHOUT NOTICE.
Ordering Information
Product Code:
DT00 Real™ Salon™ Spa
Right Hand
• Center Drain Location
• Accessories / Hardware:
Rotary Drain Kit, 30” Cable #K606
Trim Kit: 2 BMH Jet Rings #J869
2 X Trim Kit: 2 Neck Jet Rings #P556
Trim Kit: 4 HTA Jet Rings, 3 Control Panel
overlays #P205
• Trim Kit Finishes Available:
(827) – Chrome
(898) – Brushed Chrome
(815) – Satin Nickel
(829) – Bright Brass
(805) – Platinum
(826) – Brushed Nickel
(849) – Oil Rubbed Bronze
Technical Specifications
Dimensions
72” L x 42” W x 26” H
(1829 mm) L x (1067 mm) W x (660 mm) H
Drain/Overflow
A: 20 “ (508 mm) B: 14” (356 mm)
Cutout
70” (1778 mm) x 40” (1016 mm)
Total Weight
1230 lb (558 kg) / 59 lb/ft 2 (287 kg/m 2 )
Operating Gallonage
90 U.S. Gal. (341Liters)
Product Weight
179 lb (81 kg)
Skirt Mounting
Not Available
Electrical Specifications
Requires a dedicated GFCI protected separate circuit.
Blower: 120VAC, 20AMP, 60 Hz.
Motor/Pump and RapidHeat™: 240VAC, 20AMP, 60 Hz.
Heater (Standard)
Requires a dedicated GFCI protected separate circuit.
RapidHeat™: P/N BN60000
† Add 1/4” to this dimension when roughing-in for 3-wall niche.
10-1/2"
36"
14"
5-1/4"
42"
72"
3"
Motor
12" H x 24" L Service Access
Heater
Blower
18" x 4"*
© Jacuzzi Whirlpool Bath • 14801 Quorum Drive • Dallas • Texas • 75254 • www.jacuzzi.com
END VIEW
25"
42"
SIDE VIEW
72"
2"
(51 mm)
(Inlet Heater)
(Motor)
(Blower)
# FS08 12/06
DRAIN/OVERFLOW
A
B
Product Shown: Real™ Salon™ Spa Right Hand Shown Model: DT00
* Measurements inside unit represent cutout in floor to allow for drain/overflow.
Minimum Service Access dimensions given.