GE 97990 GE Wireless Optical Mouse for PCs - Manual (Page 4)

4
CONNECTING YOUR MOUSE
1. Disconnect the existing mouse.
2. Connect the receiver’s USB plug to the USB Port on your
computer.
3. Place the receiver 8” (20cm) from any other electronic device
such as your computer and monitor.
4. Install the included 2 AA batteries into the battery compartment
located on the bottom of your mouse. Position the batteries
according to the diagram in the battery compartment.
5. Turn on your computer and start your Operating System.
6. Place your Wireless Optical Mouse within 3 feet (approximately 1
meter) of the receiver for optimal communication.
7. Move the mouse to ensure there is a good connection.
8. If the mouse does not work, you may need to link your mouse.
See the Trouble Shooting section for instructions.
2 AA Batteries
Link Button
On / Off Switch
Low Battery LED