beautypg.com

Jacuzzi LED SERIES J-230 User Manual

Page 18

background image

page 4

3. Turn On Power

Turn on power to spa at the home’s circuit breaker. The heater and
filter/circulation pump will automatically activate. If the control panel
LCD flashes water temperature and “COL” or “ICE”, refer to page
29 for additional information.

4. Activate Jets Pump 1

Depress the JETS button on the control panel once to activate
jets pump #.

5. Add Start-Up Chemicals

Add the spa water chemicals as recommended by your authorized
Jacuzzi dealer. See section 3.0 “Water Quality Maintenance”
(page 27) for general guidance.

6. Establish A Stable Sanitizer Reading

Establish a stable sanitizer reading between 3 ppm and 5 ppm. To
ensure healthy water conditions, always maintain a constant sani-
tizer reading within the levels recommended by the Association of
Pool And Spa Professionals/USA printed on the inside cover of this
manual. If sanitizer levels cannot be stabilized, perform the decon-
tamination procedure steps 9-5 on page 5-6. Note: the “decon-
tamination procedure” steps 9-15 should also be used after the spa
has been “Winterized” (section 12.7, page 26 ) or has been sitting
without power for an extended period.

7. Set Spa To Heat

To warm spa water to a comfortable temperature, follow these
steps:

The LCD display on the control panel displays the actual tempera-
ture of the spa water. Press either the COOLER (-) or WARMER
(+)
button once to display the “set” temperature for 5 seconds. If
you want the water to heat to a different temperature, simply press
COOLER (-) or WARMER (+) within 5 seconds. The set tempera-
ture increases or decreases by one degree each time one of these
buttons is pressed.

• The heater will turn off when the temperature corresponding to the

thermostat setting is achieved.

Important Heater Details:
• The maximum water temperature setting for your spa is 04°F

(40°C) and the minimum setting is 80°F (27°C).

• Setting the thermostat at maximum will not accelerate the heating

process. This will only result in a higher ultimate temperature.

This manual is related to the following products: