JVC FS-H10 - Manual (Page 21)

18
3
Press TIMER SET.
The (timer) and the OFF (off-time) indicators
flash and the off-time setting appears on the
display.
If you does not need to change the off-time setting, go to
step 5.
• If you change the on-time setting, the off-time setting
changes to “– –:– –.” You need to set the off-time
setting.
4
Press PROGRAM to set the off-time
you want the unit to turn off.
The hour indication starts flashing on the
display.
1) Press
¢ or 4 to set the
hour, then press PROGRAM.
2) Press ¢ or 4 to set the
minute, then press PROGRAM.
5
Press TIMER SET.
The (timer) indicator flashes and the source
name appears on the display.
If you does not need to change the source, go to
step 7.
6
Press PROGRAM to select the
source to play.
The source name starts flashing on the
display.
• Press
¢ or 4 to select
“CD” or “TUNER,” then press
PROGRAM.
Using the Timers
Daily Timer and Sleep Timer are available.
• Before using these timers, make sure the built-in clock is
set correctly (see page 8).
Using the Daily Timer
You can set the Daily Timer when the unit is either turned on
or in standby mode.
How the Daily Timer actually works
When the on-time comes, the unit automatically turns on and
then the off-time comes, the unit automatically turns off
(standby).
• Once the timer has been set, it will be activated at the same
time everyday until the timer is turned off and the timer
setting remains in memory until you change it.
Before you start...
When using “TUNER” as the source to play, make sure to
select the desired station before turning off the power.
• In the following procedure, the clock is set to 12-hour
system.
• There is a time limit in doing the following steps. If the
setting is canceled before you finish, start again from step 1.
On the remote control ONLY:
1
Press TIMER SET.
The (timer) and the ON (on-time) indicators
flash and the on-time setting appears on the
display.
If you does not need to change the on-time setting, go to
step 3.
2
Press PROGRAM to set the on-time
you want the unit to turn on.
The hour indication starts flashing on the
display.
1) Press
¢ or 4 to set the
hour, then press PROGRAM.
2) Press ¢ or 4 to set the
minute, then press PROGRAM.
TIMER SET
PROGRAM
PROGRAM
TIMER SET
PROGRAM
PROGRAM
TIMER SET
PROGRAM
PROGRAM
Continued
FS-H10[J]timer.p65 03.6.5, 11:15 AM 18