beautypg.com

Activate index search, Start playback, Activate repeat playback – JVC HR-DD445EK User Manual

Page 15: Stop playback, Load a cassette, Index search, Repeat playback, Ntsc playback

background image

15

Index Search

Your recorder automatically marks
index codes at the beginning of
each recording. This function gives
you quick access to any one of 9
index codes in either direction.

NOTE:

Before starting, make sure the
recorder is in the Stop mode.

ACTIVATE INDEX SEARCH

1

Press PUSH JOG or (™ or £). “™ 1” or
“£ 1” is displayed on screen and search begins in
the corresponding direction.

● To access index codes 2 through 9, press PUSH JOG

or repeatedly until the correct index number is
displayed.
Ex.: To locate the beginning of B from the current

position, press PUSH JOG twice.
To locate the beginning of D from the current
position, press PUSH JOG once.

● When the specified index code is located, playback

begins automatically.

£

2

Counter Memory

Returns to the counter reading of “0:00:00” to conveniently find
a specific place on the tape automatically.

SET COUNTER MEMORY

1

Press C. (COUNTER) RESET during playback at a point
you wish to locate later. The counter reads “0:00:00”.
Then press C.MEMORY, and “M” appears in front of the
counter digits.

ACTIVATE COUNTER

MEMORY

2

When you wish to return to the designated point, press
STOP and then REW or FF.

● The tape rewinds or fast-forwards and stops at about

0:00:00 automatically.

● To cancel Counter Memory, press C.MEMORY again.

Repeat Playback

Your video recorder can automatically play back the whole tape
20 times repeatedly.

START PLAYBACK

1

Press PLAY.

ACTIVATE REPEAT

PLAYBACK

2

Press PLAY and hold for over 5 seconds, then release.

● The Play indicator ($) on the display panel blinks

slowly.

● The tape plays 20 times automatically, and then

stops.

STOP PLAYBACK

3

Press STOP at any time to stop playback.

NOTE:

Pressing PLAY, REW, FF or PAUSE also stops Repeat Playback.

NTSC Playback

Your video recorder is equipped with NTSC circuitry that can
play back NTSC tapes.

LOAD A CASSETTE

1

Insert a cassette recorded in NTSC.

START PLAYBACK

2

Press PLAY.

● "NTSC" appears on the screen for about 5 seconds.

● Some TVs shrink the picture vertically and place

black bars at the top and bottom of the screen. This is
not a malfunction on the part of either the video
recorder or the TV.

● The picture may roll up and down. This can be

corrected using the V-HOLD control found on some
TVs. (This cannot be corrected if the TV does not
have a V-HOLD control.)

● The counter and tape remaining time readings will be

incorrect.

● During search, still, or frame-by-frame playback, the

picture will be distorted, and there may be a loss of
colour.

● Depending on the type of TV, the top and bottom

portions of superimposed displays may be cut off
during NTSC playback.

%

fi

Current position

Index number

%

fi

A

B

C

D

E

F

–2

–1

1

2

3

fi

%