Jet Tools JML-1014 - Manual (Page 10)

7. Insert the spindle into the spindle pulley
aligning the key.
8. Thread the handwheel onto the spindle
leaving a little space between the
handwheel and headstock. Tighten set
screws.
9. Center the spindle pulley and tighten set
screw.
10. Wrap the belt around the motor pulley
(lower). Be sure the belt is aligned with
spindle pulley and motor pulley.
11. Tension the belt and tighten the motor plate
lock handle.
Removing and Installing the Live Center
1. Loosen tailstock lock handle (B, Fig. 9).
2. Turn the tailstock handwheel (A, Fig. 9)
counter-clockwise until the live center (C,
Fig. 9) ejects from the spindle.
3. Before installing the live center into the
spindle, the spindle must be extended out
from the tailstock body far enough to allow
the live center to “seat” in the spindle.