Jabra SP5050 User Manual
Page 6
4
Jabra JX10 Bluetooth headset
1. Charge your headset
Make sure that your Jabra SP5050 Speakerphone is fully charged
for two hours before you start using it. Use only the charger
provided in the box – do not use chargers from any other devices
as this might damage your Jabra SP5050.
Connect your Speakerphone as shown in fig 2. When the LED indi-
cator light is solid red on the car charger, your headset is charging.
When the LED indicator light is green, it is fully charged.
2. Turning your Speakerphone on and off
Press the answer / end button to turn on your Speakerphone
(see fig 1).
The power on indicator light will turn on. The connecting status
indicator light will blink twice every 2 second until the Jabra
SP5050 is connected to your mobile phone – then it will turn solid
blue.
To turn off your Speakerphone press the answer/end button until
you see a burst of flashes.
With Jabra AutoOff, your Speakerphone will automatically turn off
15 minutes after it has lost the connection to your mobile phone.
So it doesn’t matter if you don’t turn off your SP5050 when you
leave the car – SP5050 will take care of that for you.
3. Pair it with your phone
Before you can use your Jabra SP5050, you need to pair it with
your mobile phone.
1. With Jabra Autopairing, your Speakerphone will automati-
cally enter pairing mode the first time you turn it on.
2. Set your Bluetooth phone to ‘discover’ the Jabra SP5050.
Follow your phone’s instruction guide. This usually involves
going to a ‘setup,’ ‘connect’ or ‘Bluetooth’ menu on your phone
and selecting the option to ‘discover’ or ‘add’ a Bluetooth
device.* (See example from a typical mobile phone in fig 3).