John Lewis JLBIOS603 - Manual (Page 14)

14
Fast Heat-up function Fast Heat-up function Fast Heat-up function Fast Heat-up function Fast Heat-up function
After a cooking function has been selected and the temperature
has been adjusted, the cavity will gradually heat up until the
selected temperature is reached. This will take from 10 to 15
minutes, depending on selected function and temperature.
If it is necessary to reach the required temperature in a
shorter time, the Fast Heat-up function can be used.
1) Switch the oven on by pressing button .
2) Set the required cooking function and temperature as
explained in the previous pages.
3) Set the temperature by pressing button “ ” or “ ”. The
temperature will appear on the display.
4) Press Fast heat-up button. The temperature display will
show "FHU" (Fig. 17).
5) press Oven functions button and the symbol “°°°°°” will flash
for approximately 10 seconds. Now it is possible to select
the required temperature by pressing button “ “ or
“ “.
4) When the required temperature is reached, an acoustic
alarm will sound for a short time, and the temperature
display will revert to the set temperature.
This function can be used with any cooking function or
temperature.
Demo mode Demo mode Demo mode Demo mode Demo mode
This mode is intended to be used in the shops to demon-
strate the oven functionality without any power consump-
tion except the oven lamp. To activate this function the
appliance should be in stand-by mode.
— Press Fast heat-up button and “ “ for approximately
2 seconds (Fig. 18). An acoustic alarm will sound for a
short time.
— Press button and the “ id id id id id ” indication will appear
in the display.
All oven functions can be selected.
The thermometer symbol will not flash anymore and
“
id id id id id ” indication will be replaced by number digits.
Follow the Follow the Follow the Follow the Follow the above described above described above described above described above described procedure to d procedure to d procedure to d procedure to d procedure to disable isable isable isable isable
the demo mode. the demo mode. the demo mode. the demo mode. the demo mode.
Er Er Er Er Errrrrror code or code or code or code or code
The electronic programmer does a continuous diagnostic
check of the system. If some parameters are not correct,
the control unit will stop the activated functions and it will
show on the display the corresponding error code (letter F
followed by digits).
For further details, refer to chapter "Something not work-
ing“ on page 27.
Fig. 17 Fig. 17 Fig. 17 Fig. 17 Fig. 17
Fig. 18 Fig. 18 Fig. 18 Fig. 18 Fig. 18