Juniper Networks NETSCREEN 200 User Manual
Page 4

Contents
iv
User’s Guide
Establishing a Terminal Emulator Connection................................................ 22
Changing Your Admin Name and Password ................................................. 23
Setting Port and Interface IP Addresses ......................................................... 23
Viewing Current Interface Settings ............................................................23
Setting the IP Address of the Management Interface ...............................24
Setting the IP Address for the Untrust Zone Interface .................................24
Allowing Outbound Traffic .........................................................................25
Configuring the Device for Telnet and WebUI Sessions ...........................................25
Starting a Console Session Using Telnet ......................................................... 25
Starting a Console Session Using Dialup........................................................ 26
Establishing a GUI Management Session....................................................... 26
Using CLI Commands to Reset the Device .................................................... 28
Using the Asset Recovery Pinhole to Reset the Device .................................. 29