JBL Vertec Series VT4880 - Manual (Page 14)

Page 14
VERTEC SYSTEMS
SUSPENSION HARDWARE & ASSEMBLY NOTES
Arrays of similar V ER T EC Model
• Each V
ER
T
EC
model uses the matching model of Array Frame (VT488X-AF) or
Short Frame (VT488X-SF) to create clusters of the same model.
• These same frames can also be used to ground stack the various systems.
Arrays of Combined V
ER T EC Models
• Clusters of combined models (i.e. VT4887s attached under a VT4889) use
ADAPTER FRAMES to interconnect the various models.
• These frames are the:
VT4800-DA to adapt VT4887 under VT4889 or VT4880.
VT4800-CA to adapt VT4887 under VT4888.
VT4800-UA to adapt any model to any model.
Ground stacking capabilities
• All V
ER T EC models can be ground stacked using the matching model of AF or SF
frames.
• Up to 6 V
ER T EC cabinets can be safely stacked using the appropriate V ER T EC AF
frame and up to 4 cabinets when using the SF Frame.
General rigging recommendations
• Only qualified personnel should perform suspension of audio systems!
• Users should inspect every component to be rigged every time the system is used.
• Users should verify that all Quick Release Pins in the V
ER T EC cabinets and in the
suspension frames are properly locked when rigging the system.