JBL ESC333 - Manual (Page 11)

-11-
+/– buttons (11). Levels set in
one mode will stay valid for all
other modes and are not inde-
pendent. Please note that the
status-bar indicator (27) will
not display unless Adjustment
+/– buttons are pressed. And,
while the status-bar indicator
(27) is on, channel indicators
(28) and LVL (29) will not be
displayed. Also, if adjustments
are done in a mode where a
certain channel is not available,
the adjustment step for that
channel is skipped. For examp-
le, in Phantom mode the center-
channel level cannot be ad-
justed since Phantom does not
have a center channel. In
stereo, neither the center nor
the surround levels can be
adjusted since Stereo does not
feature surround speakers or a
center speaker. A seventh press
of the Level button will exit the
ESC333 from its level-
adjustment mode.
11. Adjustment
These buttons are used in
conjunction with Test (8), Delay
(9), and Level (10) to increase
or decrease a setting.
12. Bass
Press (+) to increase the level of
low-frequency information.
Press (–) to decrease the level
of low-frequency information.
13. Treble
Press (+) to increase the level of
high-frequency information.
Press (–) to decrease the level
of high-frequency information.
14–17. Input
One of these four indicators will
illuminate, depending on which
input is selected.
18–21. Surround
One of these will illuminate,
depending on which surround
mode is chosen.
22. Dolby Digital
Indicates the presence of a
Dolby Digital-encoded AC-3
digital signal.
23. 5.1-Ch
Works in conjunction with the
Dolby Digital indicator (22).
This indicator illuminates when
the Dolby Digital signal
contains 6 discrete channels of
information (one subwoofer and
five satellite channels).
24. Dolby Pro Logic
Illuminates when Dolby Pro
Logic decoding of a 2-channel
signal is taking place. This
indicator may be on by itself
(when analog inputs are used),
in conjunction with Dolby
Digital (when using a digital
input where the AC-3 format
signal contains two channels
and needs to be decoded into
multichannel) or together with
PCM (when using a digital input
where 2-channel PCM-format
data is being decoded into
multichannel).
25. PCM
Illuminates when the signal
supplied through the selected
digital input is in PCM format.
26. Late Night
Illuminates when the Late Night
compression is selected.
27. Status-Bar Indicator
These LEDS show the relative
setting of volume, bass, treble,
speaker level and speaker delay.
28. Speaker Indicator
Identifies the speaker that’s
being adjusted. LS is Left
Surround, LF is Left Front, C is
Center, RF is Right Front, RS is
Right Surround, and SUB is
Subwoofer.
29. Level
Illuminates when the ESC333 is
in speaker-level adjustment
mode.
30. Delay
Illuminates when the ESC333 is
in speaker-delay adjustment
mode.
31. On
Indicates that the ESC333 is
fully powered up.
32. Standby
Indicates that the ESC333 is
plugged into an active wall
outlet and the master switch on
the back panel is in On/Standby
position, but the unit is not
powered on.
33. Mute
Illuminates when the mute
function is activated (the
ESC333 will be on but will not
produce any sound).