beautypg.com

Common operations – JVC MX-J900 User Manual

Page 12

background image

– 9 –

Common Operations

Turning On or Off the Power

To turn on the unit, press POWER so that the
STANDBY lamp goes off.

The Powered Rolling Panel opens automatically.

To turn off the unit (on standby), press
POWER again so that the STANDBY lamp
lights up.

The Powered Rolling Panel also closes.
A little power is always consumed even while the unit is on
standby.

To switch off the power supply completely, unplug the AC
power cord from the AC outlet.

When you unplug the AC power cord or if a power
failure occurs

The clock is reset to “AM 12:00” right away, while the tuner preset
stations (see page 12) will be erased in a few days.

Setting the Clock

Before operating the unit any further, first set the clock built
in this unit.

On the unit ONLY:

1

Press PANEL OPEN/CLOSE.

The unit is turned on and the Powered Rolling
Panel opens automatically.

2

Press CLOCK/TIMER.

The hour digits start flashing on the display.

3

Press

4 or ¢ to adjust the

hour, then press SET.

• If you want to correct the hour after

pressing SET, press CANCEL. The hour
digits start flashing again.

DAILY

Canceled

ON TIME

ON TIME

Clock

setting

(The hour digits start flashing.)

REC

4

Press

4 or ¢ to adjust the

minute, then press SET.

To check the clock time

Press DISPLAY while playing any source.
• Each time you press the button, the source

indication and the clock time alternate on the
display.

To adjust the clock again

If you have adjusted the clock before, you need to press
CLOCK/TIMER repeatedly until the clock setting mode is
selected.
• Each time you press the button, the clock/timer setting

modes change as follows:

If there is a power failure

The clock loses the setting and is reset to “AM 12:00.” You need to
set the clock again.

Selecting the Sources

To listen to the FM/AM broadcasts, press FM/AM. (See
page 12.)
To play back CDs, press CD

£¥8. (See pages 13 – 15.)

To play back tapes, press TAPE

2 3. (See page 16.)

To select the external equipment as the source, press AUX.

When you press the play button for a particular source (FM/
AM, CD

£¥8, AUX, and TAPE 2 3), the unit turns on, and

the Powered Rolling Panel opens automatically (and the unit
starts playing the source if it is ready — COMPU PLAY
CONTROL).

EN01-12.MX-J900[J]/f

00.1.13, 3:03 PM

9