Jet Tools DC-650TS - Manual (Page 7)

7
WARNING
Read and understand the entire contents of
this manual before attempting assembly or
operation of the dust collector!
Failure to comply may cause serious injury!
Unpacking
1. Finish removing all contents from the
shipping carton.
2. Report any damage to your distributor.
3. Do not discard any shipping material until
after the dust collector has been assembled
and is running properly.
Contents of the Shipping Carton
1. Plastic Cover/Motor/Fan Assembly
1. Hose
1. Owner's Manual
1. Warranty Card
1. Filter
1. Hose Clamp
1. Plastic impeller guard
1. Metal Deflector
1. Elbow
1. Harware Package
Tools Required for Assembly
2. 10mm Wrenches or sockets
1. #2 Cross Point Screw Driver
The JET DC-650TS does not come with a
collector can. You can use the JET two stage
dust collector on a variety of round, metal and
plastic collector cans. The outer diameter of the
trash can should be approximately 20-1/4” – 24-
1/4” to fit properly.
Use the proper type hose (C, Fig. 5) to connect
the
dust collector to the machine being
operated. Dryer vent hose is not acceptable for
this
purpose. Contact your nearest JET
distributor for the full line of JET Dust Collector
Hoses
and Accessories. Customize your
installation and obtain maximum performance
with JET's dust hoods, hoses, clamps, fittings,
and blast gates.
Order the Dust Collection Basics Video which
covers topics such as system design, duct
material, fittings, construction and grounding.
Stock # JW1050V