JBL SCS-SAT500 User Manual

Page 5

Important Safety Note:

The

customer is solely responsi-
ble for proper selection of
mounting hardware not
included with the speaker,
and for proper assembly
and installation of the wall-
mount bracket, including but
not limited to the selection of
appropriate weight-bearing
supports and proper use of
the bracket. JBL disclaims
any liability for the selection
of mounting hardware
and/or bracket installation.
Be sure to follow these
bracket assembly and
installation instructions
carefully. If you have any
questions or doubts about
your ability to correctly wall-
mount the speakers, consult
your authorized JBL dealer
or custom installer.

Step 1: Unscrew and remove
the large Molded Nut ™. If
necessary, use the supplied
Metal Bar ∞ as a lever by
inserting it into one of the
holes in the outer edge of
the Molded Nut ™.

Step 2: Firmly grasp the Ball
and Shaft £ and pull it
straight out of the Attach-
ment Plate ¢. Avoid leaning
it to the side for leverage, as
this may break off a tab.

Step 3: Slide the Molded Nut
™ onto the Ball and Shaft
£ with the threaded open-
ing facing the ball. Thread
the Metal Nut ¡ all the way
onto the Ball and Shaft £,

with the star washer side
away from the ball. Refer to
the exploded drawing for the
proper orientation of these
parts.

Step 4: Screw the Ball and
Shaft £ into the Threaded
Insert § on the back of the
Satellite Speaker ¶ until it
is fully seated in the Threaded
Insert §, but do not tighten,
as you might dislodge the
Threaded Insert §. Such
damage would not be cov-
ered under the warranty.

Step 5: Tighten the Metal Nut
¡ with the star washer side
between the Metal Nut ¡

and the back of the

Satellite

Speaker ¶, using large
needle-nose pliers until it is
firmly seated against the back
of the Satellite Speaker ¶
and has locked the Ball and
Shaft £ and the Satellite
Speaker ¶ together.
NOTE: Once the Metal Nut ¡
is fully tightened, it may embed
some marks on the back of the
Satellite Speaker ¶. However,
these marks will be covered
by the Metal Nut ¡.
Step 6: Mount the Attach-
ment Plate ¢ into a wood
stud on the wall, using four

#10 panhead wood screws
• at least one inch long
(not supplied). Make sure
that all four screws are
driven into the stud and not
into drywall.

If the bracket

needs to be mounted in
drywall, the customer is
responsible for selecting
and using appropriate wall
anchors and screws.

IMPORTANT NOTE: The Metal
Nut ¡ must be fully tight-
ened against the Satellite
Speaker ¶ as described in
Step 5 before beginning Step
7, in order to avoid damage
to the Threaded Insert §.

WALL-MOUNTING

SCS-SAT500,300,200 OM 4/25/07 11:39 AM Page 6