Jwin JX-CD530 - Manual (Page 4)

E.3
1. Plug the cord of headphone/earphone into the PHONES jack.
2. Slide the Door Open button to open the CD door.
3. Hold the disc with the label side up and press it onto the spindle until it “clicks”
into place.
4. Close the disc compartment, press PLAY/PAUSE button, the disc will begin to spin,
the display will indicate “01”, play will begin immediately from track number 1.
5. Adjust the volume as desired.
6. Set the BASS BOOST function as desired.
7. To stop play temporarily, press the PLAY/PAUSE button.
• The elapsed playing time flashes in the display.
• Press the PLAY/PAUSE button again to resume.
8. To stop play, press the Stop Button, and the power turns off automatically after a while.
Note: Both 8cm and 12cm discs can be played in the unit.
Place only one disc at a time in the CD compartment.
TRACK SEARCH
• Press the and button during play to skip to the de-
sired track.
• Press the to skip to the next track on the disc.
• Press the to skip to the beginning of the track currently
playing.
• Press the twice or more to skip to previous tracks.
FORWARD/REVERSE SEARCH
Press and hold the skip ( ) button during play to scan the disc at high speed.
When the desired section of the disc is found, release the button. Normal play will resume.
----forward ----reverse
• If you press and hold the skip button ( ) while playing, it will scan the current
playing track forward at high speed.
• If you press and hold the skip button ( ) while playing, it will scan the current
playing track backwards at high speed.
BASS BOOST
Use the Bass Boost function to increase the bass output when
listening with headphones. During bass boost on setting, some-
times, you may hear some distortion, adjust the volume control
to a lower level when using the bass boost feature.
PROGRAMMED PLAY
The tracks on the disc can be programmed for play in any order. (Up to 24 tracks
can be programmed.)
During programming, “PROG” flashes in the display.
NOTE: Programming is possible in the STOP mode.
1. Press the PROGRAM button in the STOP MODE. The “PROG” appears in the display.
2. Press the skip button (
) to select the first track to be programmed.
3. Press the PROGRAM button again to enter the track into the memory.
4. Repeat steps 2 to 3 to program other track till you finish.
ON OFF
BASS BOOST
Program number
Track number
1 2 3
3 5 9