Connections, Specifications – JBL GTO6507SC User Manual

Page 4

Declaration of Conformity

We, Harman Consumer Group International

2, route de Tours
72500 Château du Loir
France

declare in own responsibility that the products described in this owner’s
manual are in compliance with technical standards:

EN 61000-6-3:2001
EN 61000-6-1:2001

Klaus Lebherz

Harman Consumer Group International

Château du Loir, France 4/06

JBL, Incorporated
250 Crossways Park Drive, Woodbury, NY 11797 USA
516.255.4JBL (4525) (USA only) www.jbl.com

JBL, Harman International and Grand Touring Series are trademarks of Harman International
Industries, Incorporated, registered in the United States and/or other countries. I-Mount and
Starfish are trademarks of Harman International Industries, Incorporated.

Part No. GTCOMPONENTSOM4/06

www.jbl.com

GTO507C

GTO607C

GTO6507C

GTO8607C

GTO6507SC

Type

5" (130mm)

6-1/2" (160mm)

165mm

6" x 8" (5" x 7")

165mm Shallow-

Two-way

Two-way mount

two-way

component

Power Handling

55W RMS,

70W RMS,

60W RMS,

165W Peak

210W Peak

180W Peak

Sensitivity (2.83V/1m) 91dB

92dB

Frequency

70Hz – 21kHz

55Hz – 21kHz

Response

Impedance

2 Ohms

Mounting Depth

2-5/16" (59mm)

2-1/16" (53mm)

2-3/8" (61mm)

2-1/4" (58mm)

1-13/16" (47mm)

Cutout Diameter

4-11/16" (120mm) 5-1/16" (129mm)

5-11/16" (145mm) 4-15/16" x 7-3/16"

5-11/16" (145mm)

(126mm x 183mm)

Overall Diameter

5-1/8" (131mm)

6-1/4" (159mm)

6-9/16" (167mm)

5-11/16" (145mm)

6-9/16" (167mm)

GENERAL CARE
The loudspeaker grilles may be cleaned with a damp cloth. Do not use any cleaners
or solvents on the grilles or the speaker cones.

These products are designed for mobile applications and are not intended for
connection to the mains.

A valid serial number is required for warranty coverage.

Features, specifications and appearance are subject to change without notice.

Not all models are available in all markets.

Big Lug =

Small Lug =

To AMPLIFIER
OUTPUTS

To WOOFER

To TWEETER

CONNECTIONS

Open the crossover housing by firmly
squeezing the sides of the top half and
lifting it away from the bottom. Using
screws or a wire tie, mount the
crossover using the holes provided.
Observing proper polarity, connect the
speakers and amplifier as shown in
Figures 8A–8C. Replace the cover
when you are finished making the
connections and adjustments (see
following section).

Figure 8A. Wiring connections on
the crossover network (shown with
cover on).

Figure 8B. The 0dB setting is the
reference setting. Move the jumper
to the +3dB setting if more tweeter
output is required.

Figure 8C. Locating wiring connections
on the GTO507C woofer. Other woofers
are wired similarly.

SPECIFICATIONS

Tweeter level
0dB (default)

Tweeter level
+3dB

This manual is related to the following products:

GTO6507C GTO8607C GTO507C GTO607C