Jwin JX-CD7160 - Manual (Page 9)

Mini Portable Stereo Audio System V10M10_IM_EN_04102007
www.jWIN.com - 8 -
GETTING STARTED
Connecting the Speakers
Connect the SPEAKER cables to the SPEAKER
terminals in the rear of the unit properly.
AC Operation
Before operating this unit, make sure the voltage indicated on the JX-CD7160 matches the
voltage in the wall outlet.
1. Plug
the AC POWER CORD into a standard AC wall outlet.
2. The
STANDBY/MUTE INDICATOR will light.
3. Press the POWER button. The LCD DISPLAY will light and the STANDBY/
MUTE INDICATOR will go off.
Antennas
For best FM reception, fully extend the FM antenna. For AM reception, this unit has a built-in
antenna.
Listening with Stereo Headphones
For private listening, insert the 3.5mm plug of a stereo headphone set (not included) into the
STEREO HEADPHONE JACK on the left side panel of the
JX-CD7160. Volume on the headphones is controlled by
the VOLUME knob on the unit of the VOLUME -/+ button
on the remote control. When headphones are used, sound
on the external speakers cuts off.
Note: Be sure that your headphones have an impedance of 32ohms.
Installing Batteries in the Remote Control
1. Slide open the BATTERY
DOOR in the direction of the
arrow imprinted on the door
itself.
2. Install two (2) AA size batteries
according to the polarity (+/-)
marked inside the compartment
3. Close the BATTERY DOOR.
Note: Remote Control buttons correspond with the similarly labeled buttons on the main unit.
The recommended distance for remote operation is 16 feet or less.