Jet Tools JPL-358 - Manual (Page 6)

6
Receiving
1. Remove contents from the box.
2. Inspect contents for shipping damage and report
damage, if any, to your distributor.
3. Be sure to keep the box and packing material
should you need to pack the lathe for moving.
4. Do not clean the lathe with anything other than a
damp cloth or a mild solvent. Use of heavy
solvents, paint thinner, gasoline, etc. will
damage painted surfaces.
Contents of box (Fig. 2):
1 Lathe
(A)
1 Knockout rod (B)
9 10mm Bushings (C)
1 Pen mandrel (D)
1 Live center (E)
1 Spur center (F)
3 Chisels – skew, parting, domed scraper (G)
1 Goggles
1 Owner’s
manual
1 Warranty card
Assembly
The JPL-358 is fully assembled and comes ready to
use right out of the box. However, it is good practice
to thoroughly check the tool for loose fasteners,
handles, etc. before use.
Four holes are provided in the base of the lathe for
bolting it to a table.
Adjustments
Tailstock
Turn handwheel (A, Fig. 3) clockwise to move
tailstock spindle forward; counterclockwise to retract
tailstock spindle. To lock the spindle, use the lever
(B, Fig. 3).
Loosen the tailstock with the attached wrench (C,
Fig. 3) and slide tailstock to desired position. Re-
tighten with wrench.