John Deere AT-3105-J - Manual (Page 9)

3/8-Inch Angle-Head Impact Wrench Operator's Manual
9
Troubleshooting
Specifications
ITEM
Drive ---------------------------------------------------- 3/8"
Free Speed ------------------------------------------- 9,000 RPM
Impacts per minute --------------------------------- 1,800 IPM
Torque range ----------------------------------------- 20-90 ft./lbs.
Length -------------------------------------------------- 5 1/2"
Weight -------------------------------------------------- 2 5/8 lbs.
Air inlet ------------------------------------------------- 1/4" NPT
Average air consumption ------------------------- 3 CFM
Maximum operating pressure -------------------- 90 PSI
Recommended Hose Size ------------------------ 3/8" I.D.
Loss of Power
1. Check air supply. For rated
performance, 90 PSI air
pressure is required at the
tool, with tool operating
2. Check for wet or dirty air.
Wet air tends to wash
lubricant away. Dirt or
foreign matter will impede
the action of the motor. If
dirt or water has entered the
tool, flush with John Deere
AT-4003.
3. Contact your customer
service.
1. Low air pressure
2. Improper lubrication or
dirt build up
3. Worn motor parts, or
other problems
Problem Symptom Solution