beautypg.com

Getting started, English, Before installation – JVC RX-7001PGD User Manual

Page 6: Checking the supplied accessories, Setting the voltage selector switch, Connecting the fm and am antennas

background image

3

English

ANTENNA

AM

EXT

AM

LOOP

FM 75
COAXIAL

AM

LOOP

ANTENNA

AM
EXT

FM 75
CO

AX

IAL

AM

LOOP

ANTENNA

AM
EXT

FM 75
CO

AX

IAL

Getting Started

This section explains how to connect audio/video components and speakers to the receiver, and how to connect the
power supply.

Before Installation

General

• Be sure your hands are dry.
• Turn the power off to all components.
• Read the manuals supplied with the components you are going to

connect.

Locations

• Install the receiver in a location that is level and protected from

moisture.

• The temperature around the receiver must be between –5˚C and

35˚C (23˚F and 95˚F).

• Make sure there is good ventilation around the receiver. Poor

ventilation could cause overheating and damage the receiver.

Handling the receiver

• Do not insert any metal object into the receiver.
• Do not disassemble the receiver or remove screws, covers, or

cabinet.

• Do not expose the receiver to rain or moisture.

Checking the Supplied Accessories

Check to be sure you have all of the following items, which are
supplied with the receiver.
The number in the parentheses indicates quantity of the pieces
supplied.

• Remote Control (1)

• Batteries (2)

• AM Loop Antenna (1)

• FM Antenna (1)

• AC Plug Adaptor (1)

If anything is missing, contact your dealer immediately.

Setting the Voltage Selector Switch

Before connections, always do the following first if necessary.

Set the correct voltage for your area with the voltage selector switch
on the rear panel. Use a screw driver to rotate the switch so the
number the arrow is pointing at is the same as the voltage where you
are plugging in the receiver.

A. Using the Supplied FM Antenna

The FM antenna provided can be connected to the FM 75

COAXIAL terminal as temporary measure.

B. Using the Standard Type Connector (Not Supplied)

A standard type connector should be connected to the FM 75

COAXIAL terminal.

Note:

If reception is poor, connect the outdoor antenna.
Before attaching a 75

coaxial cable (the kind with a round wire

going to an outdoor antenna), disconnect the supplied FM antenna.

Connecting the FM and AM
Antennas

FM Antenna Connections

B

FM Antenna

Outdoor FM Antenna Cable

Extend the supplied FM antenna horizontally.

A

VOLTAGE SELECTOR

220V

230

-

240V

127V

110V

Voltage Mark

EN01-09.RX-7001PGD[U,US]/f

00.5.31, 10:53 AM

3