Jacuzzi J-SHA - Manual (Page 13)

J-Sha II Owner's Manual
80-130
130-220
110-150
TIME
SPEED
INTENSITY
+
+
_
+
_
0 25
_
TONIC
RELAX
+
+
+
_
_
_
MIX
ON
OFF
ON/OFF BUTTON
& LED
BACK JETS BUTTON
& LED
TONIC/RELAX BUTTON
& LED
BODY WEIGHT BUTTON
& LEDs
TIME BUTTON
& LED SCALE
SPEED BUTTON
& LED SCALE
INTENSITY BUTTON
& LED SCALE
START UP
Press ON/OFF button.
On start-up the J-Sha II will be in the default mode:
BACK JET LED lights up. Back jets operate after
about 2 seconds.
The TONIC indicator will be on. The flow from the
jets is from the bottom upward.
BODY WEIGHT of 110-150 LED will be on.
DURATION, SPEED and INTENSITY relative indica-
tors will be on.
The DURATION, SPEED and POWER of the back jets
have been preprogrammed for each body weight range.
The duration for 80-130 lbs. is 15 minutes, 110-150
lbs. is 18 minutes and 130 -220 lbs. is 21 minutes.
The speed is the velocity at which water moves up or
down on the back jets. The intensity is the water pres-
sure from the jets.
During the cycle, both speed and intensity gradually
increase to a maximum level determined for each body
weight range.
VARIATIONS FROM DEFAULT SETTINGS
BODY WEIGHT RANGE:
Press the BODY WEIGHT button until the appropri-
ate LED comes on. The duration will automatically
change the length of the cycle and the maximum
power of the jets.
TONIC to RELAX:
Press the TONIC/RELAX button. The RELAX LED
comes on. The flow from the jets is now from top to
bottom.
TIME, SPEED and INTENSITY:
Repeatedly press + or - buttons for each function.
Variations from the standard value are displayed by
the relative LED scales.
NOTE: During the BACK JETS (Shiatsu) cycle, the in-
tensity and speed of the back jets are gradually in-
creased. Any change of these values has an immedi-
ate effect.
START UP BACK JETS
9