Troubleshooting – JVC JX-B555 User Manual

Page 24

-EN

Troubleshooting

Power

No power

Unit cannot be turned
OFF

Symptom

Page

Cause

Remedy

• Is the power cord disconnected from

the AC outlet?

• Make sure that the DUBBING LOCK

function is set to ON.

• Insert the power plug firmly into the AC

outlet.

• Press the POWER button after setting

the DUBBING LOCK function OFF.

• Is the required video component con-

nected to the corresponding INPUT/
OUTPUT terminals correctly?

• Is the monitor TV connected to the

MONITOR OUT terminals correctly?

Playback

Required
picture won’t appear

• Check the connections again and re-

connect correctly.

• Check the connections again and re-

connect correctly.

The picture appears
distorted during
playback

• Is the LOOP PROTECT button pressed

OFF?

• Set the LOOP PROTECT button to ON.

• Are the playback and recording VCRs

connected correctly to the INPUT/
OUTPUT terminals? Also, is the cor-
rect SOURCE SELECT button se-
lected?

• Is the DUBBING LOCK function set?

• Is the input select switch on the re-

cording VCR set to the “AUX” posi-
tion?

• Is the video input select switch on the

recording VCR with S-VIDEO termi-
nals set to the “S-VIDEO IN” position
or “VIDEO input” position?

Recording

No picture recorded
on the edited tape.

• Check the connections again and re-

connect correctly before s e l e c t i n g
the correct SOURCE SELECT button.

• Press DUBBING LOCK to OFF before

pressing a SOURCE SELECT button.

• Set the input select switch on the re-

cording VCR to “AUX”.

• Set the video input switch on the re-

cording VCR to the correct position.

• Some video software may contain sig-

nals to prevent it from being copied. If
you try to copy such a program, the
results will not be viewable.

• Conversion is not possible from the

component terminal to the S-VIDEO/
VIDEO terminals.

Dubbing operations
are not possible when
using equipment con-
nected to the compo-
nent terminal.

• Use the S-VIDEO terminal or connect

a recording VCR to the MONITOR OUT
2 terminal.

—

10,14

11,19

12,13

14, 20

—

• The JX-S555 incorporates a microcomputer, which may malfunction due to external interference

or noise. If this trouble cannot be resolved by checking the items in the following table, reset the
microcomputer by turning off the JX-S555, unplugging its power cord from the wall outlet, plug-
ging it in again and then checking the operation.

• Are the video components etc. con-

nected to the AUDIO input terminals
correctly?

No sound recorded
on the edited tape

• Check the connections again and re-

connect correctly.