JBL LS326C User Manual

Page 5

7. Screw down each of the four

Phillips-head screws, alternat-
ing between the four screws.
The locking tabs will swivel into
place and secure the unit to the
rear surface of the wall panel.
Hand-tighten with a nonpow-
ered, straight-handle regular
screwdriver only. Do not use
a socket wrench, a powered
screwdriver, a drill or any other
powered tool. Confirm that the
speaker is firmly and securely
held in place and that all four
locking tabs are firmly resting
against the wall panel.

L226W, LS326W

1. Remove the plastic paint shield

from the speaker frame.

2. Determine the correct speaker

location.
NOTE: Use the included tem-
plate when cutting the drywall.

3. NOTE: Always allow at least a

1/2" between a wall stud and the
speaker cutout, or the locking
tabs will not be able to swivel
into place.

≥1/2"

4. Ensure that the drywall or

plywood board or other appro-
priate wallboard is at least
1/2" thick, and confirm that the
board material is capable of
withstanding the weight of the
speaker you will be installing.
Cut the drywall.

5. Connect the speaker wires to

the speaker.

6. Make sure all four locking tabs

are properly positioned against
the locking tab stops that are
located on the speaker frame
(see Figure 6 below). After con-
firming this, carefully place the
frame assembly in the wall and
confirm that there is no more
than 1/8" play between the
frame and the wall cutout. After
positioning the speaker in the
mounting location, back each
screw out one full turn (turn
counterclockwise).

8. Attach the metal grille and logo,

if desired.

Figure 6.

StudioL om.qxd 8/8/07 4:56 PM Page 5