Jet Tools GH-1340W - Manual (Page 6)

6
WARNING
Read and understand the entire contents of
this manual before attempting set-up or
operation!
Failure to comply may cause serious
injury!
Contents of the Shipping Container
1 Lathe
1 Steady Rest
1 Follow Rest
1 6" Three Jaw Chuck w/ Top Reversing
Jaws (Direct Mount)
1 8" Four Jaw Chuck with Backplate
1 12" Face Plate (strapped to container floor)
1 Backplate
1 Tool Box
Tool Box Contents:
1 No. 1 Cross Point Screwdriver
1 No. 1 Flat Blade Screwdriver
4 Open End Wrench
(9-11, 10-12, 12-14, 17-19mm)
6 Hex Socket Wrench (2.5, 3, 4, 5, 6, 8mm)
2 Shear Pin
1 30T Change Gear
1 32T Change Gear
2 40T Change Gear
1 Oil Can
2 No. 3 Morse Taper Dead Center
1 No. 5 to No. 3 Spindle Sleeve
6 Leveling Pads
1 Chuck Key
1 Key for Cam Locks
1 Tool Post Wrench
1 Owner’s Manual
1 Warranty Card