John Deere ET-3410-J - Manual (Page 16)

16 Metal Cutting Saw Operator's Manual
Operation
PRE-OPERATION:
SETTING BLADE DEPTH
WARNING: DISCONNECT POWER CORD
BEFORE ADJUSTING BLADE DEPTH.
1. Disconnect power cord.
2. Loosen T-knob (A). (Fig. 3)
3. Raise or lower the saw base to the desired
position. For proper depth setting, the blade should
extend no more than 6 mm (1/4 in) below the
material being cut.
4. Tighten T-knob (A).
(Fig. 3)