Jura Capresso 68191 - Manual (Page 27)

READY .
• Push and hold the P button (Fig. 4) until display shows RINSE .
• Push the P button again. The display again shows RINSE .
• Push the P button a third time. The display shows RINSING .
After a few seconds the rinse cycle stops automatically. READY .
ENA 5 only: turn the spout again to the 1- or 2-cup position.
19. ENERGY SAVING MODE
The ENA is set to
ENERGY – . This means the machine is
always ready to brew coffee without any wait.
You can program an energy savings mode. Five minutes after
the last brewing the ENA lowers the stand-by temperature. In
case you want to brew coffee the machine will then heat up for
approx. 30 seconds.
To change the energy setting:
READY ,
• Push and hold the P button (Fig. 4) until the display shows
RINSE .
• Turn the Rotary Dial until the display shows ENERGY -
• Push the Rotary Dial ECONOMY –
• Turn the Rotary Dial to ECONOMY
✓
• Push the Rotary Dial to confirm: OK, ENERGY
✓
.
• Push the P button to leave the programming mode. READY .
20. CHANGING THE AUTO-OFF SETTING
The ENA is pre-set to turn itself off 2 hours after last use.
Auto-Off can be set from .5 hrs. to 9 hrs or deactivated (
--- HRS ).
Recommendations:
• If you use the machine only in the morning, leave the auto-off
at 2 hours.
• If you use the machine all day change the setting to a larger
interval, e.g. 4 hours. This way the machine is always ready to
brew coffee.
Changing the AUTO-OFF setting (e.g. from 2 HRS to 4 HRS)
READY ,
• Push and hold the P button (Fig. 4) until the display shows
RINSE .
• Turn the Rotary Dial until the display shows OFF AFTER .
• Push the Rotary Dial 2 HRS .
• Turn the Rotary Dial to 4 HRS .
• Push the Rotary Dial to confirm: OK , OFF AFTER .
• Push the P button to leave the programming mode. READY .
21. CHANGING FROM OZ to ML (UNIT)
The cup size can be displayed in ounces
OZ or milliliters ML .
• Push and hold the P button (Fig. 4) until the display shows
RINSE .
• Turn the Rotary Dial until the display shows UNIT
• Push the Rotary Dial OZ
• Turn the Rotary Dial to ML
• Push the Rotary Dial to confirm: OK , UNIT
• Push the P button to leave the programming mode. READY .
22. CHANGING THE LANGUAGE
Your ENA is set to ENGLISH. The following languages can be
selected:
French (
FRANCAIS ), Italian ( ITALIANO ), Dutch ( NL ) German
( DEUTSCH ), Spanish ( ESPANOL ), Portugese ( PORTUGUES )
Example: from English to Spanish
• Push and hold the P button (Fig. 4) until the display shows
27.