Jet Tools JDP-17MF - Manual (Page 11)

11
Assembly
1. Place the base (A, Figure 1) on a level floor.
2. With a 17mm wrench attach the column
assembly (B, Figure 1) to the base (A,
Figure 1) with four M10 x 40 hex cap bolts
(C, Figure 1). Tighten firmly.
3. Thread lock handle (D, Figure 2) into the
table bracket (E, Figure 2).
4. Loosen the set screw (F, Figure 3) on the
raising handle (G, Figure 3) with a 3mm hex
wrench.
5. Slide the handle onto the table bracket
shaft.
6. Turn the handle until the set screw is
opposite the flat section on the shaft, and
tighten the set screw to secure the handle.
7. Insert the table (H, Figure 3) into the table
bracket.
8. Tighten the table lock handle (I, Figure 3).
9. With the aid of a second person, carefully lift
the head onto the column top.
The head assembly is heavy.
Use care when lifting onto the column.
10. Rotate head assembly until sides of the belt
cover are parallel with the sides of the base.
11. Tighten two set screws (A, Figure 4) with a
5mm wrench until they are snug.
Figure 1
Figure 2
Figure 3