JVC CA-MXGB6 - Manual (Page 28)

25
Using the Timers
There are three timers available—Daily Timer, Recording
Timer, and Sleep Timer.
Before using the timers, you need to set the clock built in the
unit. (See “Setting the Clock” on page 9.)
Using Daily Timer
With Daily Timer, you can wake to your favorite music or
radio program. You can set the timer whether the unit is on or
off.
How Daily Timer actually works
The unit automatically turns on, set the volume level to the
preset level, and starts playing the specified source when the
on-time comes (the
indicator flashes while the timer is
operating). Then, when the off-time comes, the unit
automatically turns off (stands by).
Daily Timer works every day unless you cancel it.
• There is a time limit in doing the following steps. If the
setting is canceled before you finish, start from step 1 again.
• If you have made a mistake while setting timer, press
CANCEL/DEMO. (However, this does not always work. If
CANCEL/DEMO does not work, press CLOCK/TIMER
repeatedly and start from step 1 again.)
Before you start...
• When using the tuner as the source to play:
— Make sure to preset a station you want to play. (See
page 12.)
• When using a CD as the source to play:
— Make sure there is a CD you want to play on the
currently selected disc number tray.
• When using a tape as the source to play:
— Make sure that a tape you want to play is in the deck
A if there are tapes in both the deck A and B.
• When using the external component as the source to
play:
— Set the timer equipped with the external component
at the same time.
DAILY
Canceled ON TIME
(Recording Timer)
CLOCK
(See page 9.)
REC ON TIME
(Daily Timer)
WOOFER
WOOFER
WOOFER
On the unit ONLY:
1
Press CLOCK/TIMER
repeatedly until “DAILY”
appears on the display.
indicator lights up and the DAILY (daily timer)
indicator starts flashing on the display.
• Each time you press the button, the clock/timer setting
modes change as follows:
2
Press CLOCK/TIMER again.
“ON TIME” appears for 2 seconds, then
the unit enters on-time setting mode.
3
Set the on-time you want the
unit to turn on.
1) Press ¢ or 4 to set the
hour, then press SET/DISPLAY.
2) Press ¢ or 4 to set the
minute, then press SET/DISPLAY.
“OFF TIME” appears for 2
seconds, then the unit enters off-
time setting mode.
4
Set the off-time you want
the unit to turn off (on
standby).
1) Press
¢ or 4 to set the
hour, then press SET/DISPLAY.
2) Press ¢ or 4 to set the minute,
then press SET/DISPLAY.
The unit enters source selecting mode.
MXGB6&5[B]_23-32.p65 04.1.21, 5:33 PM 25