Jwin JT-P433 - Manual (Page 15)

Vintage Design Telephone with Caller ID V10M10_IM_EN_01282008
www.jWIN.com - 14 -
OPERATIONAL INSTRUCTIONS
Dialing IP Number
- When the IP was set as ‘On’, pick the handset and if press the first digit is
long distant code, then it will run by IP format automatically or
- Under off-hook state, when reviewing the incoming and outgoing call, if
the first digit of displaying number is long distant code, press the
SET/BACK button, then it will run by IP format after hook the phone once.
- Under on-hook state, when reviewing the incoming and outgoing call, if
the first digit of displaying number is long distant code, press the
SET/BACK button and it will run by IP format automatically.
Storing 2 One-Touch Dialing Memories
- Under the on-hook state, press the STORE button.
- The LCD will display “PLS INPUT NUMBER”. Enter the desired number
by using keypad
- Press M1 or M2.
Storing 2 One-Touch Dialing Memories from Incoming Calls
- During the incoming call, press the STORE button.
- The LCD will display “PLS INPUT NUMBER”. Press M1 or M2 to store the
incoming number.
Dialing From One-Touch Memories
- Under off-hook state, press the desired one-touch button (M1/M2)
- Press the SET/BACK button and the number will be dialed out
automatically.
- Under off-hook state, press the desired one-touch button (M1/M2) and the
number will be dialed out automatically.
Deleting a One-Touch Memory Number
- Under off-hook state, press M1/M2 and it will show the stored number.
- Press the DEL button twice to erase the number and the LCD will display
“NO CODE”
Storing 10 Two-Touch Dialing Memories
- Under the off-hook state, press the STORE button.
- The LCD will display “PLS INPUT NUMBER”. Enter the desired number
by using keypad
- Press the STORE button again and the LCD display “INPUT ADDR”
- Press the desired two-touch location from 0-9.
Storing 10 Two-Touch Memories from Incoming Calls
- During the incoming call, press the STORE button.
- The LCD will display “PLS INPUT NUMBER”. Press STORE button again
- Then the LCD will display “PLS INPUT ADDR”, press the desired two-
touch location from 0-9