GE RM24940 - Manual (Page 8)

24940 manual 8/19/03 9:04 AM Page 8
SETUP
Programming For VCR
Most GE, RCA and ProScan VCRs will not
require programming. Check to see if your
VCR responds to the remote before you
begin programming.
1. Manually turn on
the VCR. Find the three
CODE digit code for your VCR
SEARCH
at the back of the
instructions. INDICATOR
LIGHT
2. Press and hold the
CODE SEARCH button
until the INDICATOR
LIGHT lights, then
release the CODE
SEARCH button.
3. Press and release the
VCR button (The INDI­
CATOR LIGHT will
blink then remain lit.
4. Enter the code using
the Number Buttons.
After your code is
entered, the INDICA­
TOR LIGHT will turn
off. If the code is not
valid, the INDICATOR
LIGHT will blink. Check
the code list and repeat
process.
CHAN +
ON•OFF
1 2 3
4 5 6
7 8 9
0
(OFF)
(BLINK)
VCR
5. Aim the remote at your VCR and press
the ON•OFF button. Your VCR should turn
off.
NOTE: If your VCR does not respond, try all
the codes for your brand. If the codes do not
work, or your brand is not listed,
try the Code Search method on Page 12.
6. With your VCR on, press CHAN+
(CHANNEL UP). If the VCR responds, no
further programming is required.
7. Enter your
code here for easy
reference.
VCR CODE
7