Jet Tools DC-1200A - Manual (Page 5)

5
WARNING
Read and understand the entire contents of
this manual before attempting assembly or
operation of the dust collector!
Failure to comply may cause serious injury!
Unpacking
1. Finish removing all contents from the
shipping carton.
2. Report any damage to your distributor.
3. Do not discard any shipping material until
after the dust collector has been assembled
and is running properly.
Contents of the Shipping Carton
1 Bag Hanger
1 Base
1 Plastic Cover
1 Hanger Bracket
1 Hose
1 Owner's Manual
1 Warranty Card
1 Motor/Fan Assembly
1 Collector Bag
1 Filter Bag
2 Hose Clamps
1 Retainer Strap
4 Casters
1 Inlet Cover & Hose Inlet
3 Support Legs
1 Bag of Assembly Hardware
16. M8 x 16 Hex Cap Bolts
34. M8 Flat Washers
8.
M6 x 12 Pan Head Flange Bolts
10. M8 Hex Nuts
Tools Required for Assembly
2. 1/2” or 13mm Wrenches or sockets
1. 9/16” or 14mm Wrench or socket
1. #2 Cross Point Screw Driver